Page 28 of 35 Document No: 9961 Revision: F Issue Date: Jan-29-2018
This document and all copies are the property of Spider
®
. All dimensions and data are indicative only.
The user must ensure that the equipment complies with local rules and regulations.
= Inspect
= Verify
= Perform process
Check run voltage. If not correct, do any or all of the
following:
Run separate cords for each hoist.
Use shorter cords.
Use short cord with larger wires.
Add a booster transformer at the power source.
Increase hand pressure on the wire rope while rotating the
Take the wire rope out, rotate it 180° and put it back into the
Poor bullet: prepare new end.
End of wire rope is bent or kinked: prepare new end.
Dirt or other material is obstructing the rope inside the hoist.
Push the overspeed brake test button and wait to be rescued.
Check and correct the following:
Clear obstructions such as dirt or other materials.
Wire rope may be worn out. Call your supervisor.
Hoist parts may be worn out. Call your supervisor,
More troubleshooting solutions on next page
To Next Page
Loading...