Page 8 of 35 Document No: 9961 Revision: F Issue Date: Jan-29-2018
This document and all copies are the property of Spider
®
. All dimensions and data are indicative only.
The user must ensure that the equipment complies with local rules and regulations.
25. Avoid power lines. Make sure the platform or hand tools cannot swing or be blown within a minimum
of 10 feet of a power line. Check your local codes for minimum distances. Never, under any
circumstances, rig a platform above electrical power lines.
26.
elevator, distilleries, ship or silo interiors, mines, around coal handling equipment, or around explosive
organic vapors or dust.
27. Never use hoists and aluminum platforms around caustic materials, acids, or acid fumes. Use hoist
covers when corrosive materials are present.
If the hoist is suspended in the air and the motor runs but the wire rope does not move through
the hoist, STOP the hoist immediately! Damaged wire rope may be jammed inside the hoist.
Any attempt to move the hoist up or down could damage equipment or cause injury or death.
hazards. This list is not complete! It is provided to increase safety awareness on the job site.
between the platform and the building or structure.
or severing between moving machine parts.
because of one or more of the following:
Increase in vertical load on suspension wire because the platform encounters an obstacle,
Platform catches on overhang when going up.
rigging failure can cause falling.
due to loss of traction.
due to damaged wire rope.
To Next Page
Loading...