Safety Waukesha Cherry-Burrell
Page 6 95-03009 10/2010
Safety
READ AND UNDERSTAND THIS MANUAL
PRIOR TO INSTALLING, OPERATING OR SERVICING THIS EQUIPMENT
Waukesha Cherry-Burrell recommends users of our equipment and designs follow the latest Industrial Safety Stan-
dards. At a minimum, these should include the industri
al safety requirements established by:
1. Occupational Safety and Health Administration (OSHA), Title 29
of the CFR
Section 1910.212- General Requirements for all Machines
2. National Fire Protection Association, ANSI/NFPA 79
ANSI/NFPA 79-
Electrical Standards for Industrial Machinery
3. National Electrical Code, ANSI/NFPA 70
ANSI/NFPA 70- National Electrical Code
ANSI/NFPA 70E- Electrical Safety Requirement for Employee Workplaces
4. American National Standards Institute, Sectio
n B11
Attention: Servicin
g energized industrial equipment can be hazardous. Severe injury or death can result from electri-
cal shock, burn, or unintended actuation of controlled equipment. Recomm
ended practice is to disconnect and lockout
industrial equipment from power sources, and release stored energy, if present. Refer to the National Fire Protection
Association Standard No. NFPA70E, Part II and (as applicable) OSHA rules for Control of Hazardous Energy Sources
(Lockout-Tagout) and OSHA Electrical Safety Related Work Practices, including procedural requirements for:
• Lockout-tagout
• Personnel qualifications and train
ing requirements
• When it is not feasible to de-energize and lockout-tagout electr
ical circuits and equipment before working on or
near exposed circuit parts
Locking and Interlocking Devices: These devices sh
ould be checked for proper working condition and capability of
performing their intended functions. Make replacements only with the original manufacturer’s renewal parts or kits.
Adjust or repair in accordance with the manufacturer’s instructions.
Periodic Inspection: Industr
ial equipment should be inspected periodically. Inspection intervals should be based on
environmental and operating conditions and adjusted as indicated by experience. At a minimum, an initial inspection
within 3 to 4 months after installation is recommended. Inspection of the electrical control systems should meet the rec-
ommendations as specified in the Nation
al Electrical Manu
facturers Association (NEMA) Standard No. ICS 1.3, Pre-
ventative Maintenance of Industrial Control a
nd Systems Equipment, for the general guidelines for setting-up a periodic
maintenance program.
Replacement Equipment: Use only repla
cement parts and devices recommended by the manufacturer to maintain
the integrity of the equipment. Make sure the parts are properly matched to the equipment series, model, serial num-
ber, and revision level of the equipment.
Warnings and cautions are provided in this manual to help avoid se
rious injury and/or possible damage to equipment:
DANGER:
marked with a stop sign.
Immediate hazards which WILL result in severe personal injury or death.
WARNING:
marked with a warning triangle.
Hazards or unsafe practices which COULD result in severe personal injury or death.
CAUTION:
marked with a warning triangle.
Hazards or unsafe practices which COULD result in minor personal injury or product or property damage.