EasyManuals Logo

SRAM RockShox SIDLuxe Select+ 2P User Manual

SRAM RockShox SIDLuxe Select+ 2P
55 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #42 background imageLoading...
Page #42 background image
42
Piston Service
Gently clamp the seal head into the vise. Push the compression ball
out of the backside of the seal head through the bleed port.
Do not replace the compression ball at this time; you will
replace it later.
Do not reuse the compression ball.
Clamp the shaft eyelet into a vise and install the Clamp the shaft eyelet into a vise and install the seal head/air piston
onto the damper shaft.
NOTICE
Remote shocks: To prevent damage to the remote cable stop,
position the eyelet in the vise so that the remote cable pulley is clear
of the vise jaws.
Remove the o-ring from the middle of the compression poker. Remove
the o-rings on the valve slider.
Apply grease and install new o-rings.
12
1.5 mm
13
RockShox Dynamic Seal Grease
14
RockShox Dynamic Seal Grease RockShox Dynamic Seal Grease

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the SRAM RockShox SIDLuxe Select+ 2P and is the answer not in the manual?

SRAM RockShox SIDLuxe Select+ 2P Specifications

General IconGeneral
BrandSRAM
ModelRockShox SIDLuxe Select+ 2P
CategoryBicycle Accessories
LanguageEnglish

Related product manuals