Hardware layout and configuration UM2435
26/48 UM2435 Rev 2
7.4.2 ST-LINK/V2-1 firmware upgrade
The ST-LINK/V2-1 embeds a firmware upgrade mechanism for in-situ upgrade through the
USB port. As the firmware may evolve during the life time of ST-LINK/V2-1 (for example
new functionality, bug fixes, support for new microcontroller families), it is recommended to
check for updates on www.st.com before starting to use the Nucleo-68 board.
Using the ST-LINK/V2-1 to program/debug and supply the on-board MCU
To program the on-board STM32WB55, plug in the jumper JP1[7-8] connector, as shown in
Figure 17.
Figure 17. ST-LINK debugger: JP1 configuration for on-board MCU
To Next Page
Loading...
