UM1467 Using IAR Embedded Workbench® for ARM
Doc ID 022172 Rev 1 18/46
7. If your source files include header files, select the C/C++ Compiler category, open the
Preprocessor tab, and specify their paths as shown in Figure 18. The path of the
include directory is a relative path, and always starts with the project directory location
referenced by $PROJ_DIR$
Figure 18. C/C++ Compiler > Preprocessor tab
8. To set up the ST-Link embedded debug tool interface, select the Debugger category,
open the Setup tab and from the drop-down Driver menu, select ST-Link as shown in
Figure 19.
Figure 19. Debugger > Setup tab
9. Open the Debugger tab and select Use flash loader(s) as shown in Figure 20.
Figure 20. Select Flash loaders
To Next Page
Loading...
Need help?
General
