Using IAR Embedded Workbench® for ARM UM1467
19/46 Doc ID 022172 Rev 1
10. Select the ST-Link category, open the ST-Link tab and select SWD as the connection
protocol as shown in Figure 21.
Figure 21. ST-Link communication protocol
11. Click OK to save the project settings.
12. To build your project, follow the instructions given in Section 6.1: Building an existing
EWARM project on page 11.
13. Before running your application, establish the connection with the
STM32F4DISCOVERY board as described in Section 2: Getting started.
14. To program the Flash memory and begin debugging, follow the instructions given in
Section 6.2: Debugging and running your EWARM project on page 12.
To Next Page
Loading...
