MAINTENANCE
§ETTIN6!!i
Maintenance Settings includes all
of
the items in Manager Settings, plus additional items for
Service and Diagnostic use. Your Service Representative may need
to
check accumulated data
about the past usage
of
your treadmill, test its motor and display controls, or investigate error
messages. For these reasons, your treadmill
is
equipped with Maintenance Settings.
To
enter
Maintenance Settings:
• Press and
hold
rn,
f),
and
[START]
together.
• Release
IEl
• Listen for a beep and see MAINTENANCE SETTINGS in the display momentarily.
• Release the remaining keys. See UNITS in the Alphanumeric Display.
The following keys are available in MAINTENANCE SETTINGS:
INCLINE
Keys: Display the next and previous data item, respectively. Keys will
repeat
if
held.
SPEED
Keys: Adjust the value
of
the displayed data itemup and down, respectively,
in increments
of
1unit or 0.01 unit, as appropriate for the data item. They do not save
the new value - see
ISTART]
below.
Key: Updates (saves) the value
of
the displayed data item in erasable programmable
read-only memory (EPROM).
Key: Exits Configure Mode and restarts the treadmill greeting.
[Gl]··
·
[~]
Number/Program
Select Keys: Enter new data item values.
If
the UNITS data
item is displayed,
0 starts Display Test Mode and
mJ
starts Motor Test Mode.
Heart
Rate
Key: Displays the default value
of
the item, whereafter you may save it
using
[STARTI.
Exception: Displays DISTANCE instead
of
0 for LSTDCK and LSTBLT.
Use C and I
START
I
to
reset the "error" data items
to
zero after service. These items are
NO STO through EL NOZ and LSTERR through LST TM in the list below.
To
leave MAINTENANCE SETTINGS, press
[STopl.
§TAR
TRAC
4S00
TREADMILL
Owner"s
Manual
S9
To Next Page
Loading...
