The following keys are available in Motor Test Mode:
INCLINE
Keys: Adjust voltage
to
incline motor to make running deck incline up
and down in increments
of
1%. Keys will repeat ifheld.
DANGER:
Do not adjust the voltage below the lowest allowable ELMAX=25 (0.49 volts) or
above the highest allowable ELZERO=242 (4.75 volts),
as
safety features are turned
off
in Motor
Test Mode, and mechanical damage may ensue.
SPEED
Keys: Adjust PWM duty cycle
to
make motor speed go up and down in
increments
of
0.1
mph (UNITS=English) or
0.1
kmlhr (UNITS=Metric).
Heart
Rate
Key: Starts automatic calibration
of
MIN PWM,
1/2
MAX, and MAX PWM
for MIN SPD and MAX SPD range. Calibration lasts less than 3 minutes and will move the
running belt. Press
ISTOJ:l]
when running belt has stopped, to save calibration.
Key: Starts bum-in (continuous operation
of
running belt and incline screws) using
one
of
the Program Selections at maximum speed. Press
ISTOJ:lI
to stop bum-in.
Key: Exits Motor Test Mode and enters Operating Mode. Stops bum-in.
[E:J]
Number/Program
Select Key: Selects letter Z or M following Elevation (Incline) data
numeral to signify that numeral may be saved
as
ELZERO or ELMAX, respectively.
To
leave Motor Test Mode and enter Operating Mode, press and release
ISTOJ:lI.
D,§PLAY
TE§T
ManE
Display Test Mode allows you to test the light-emitting diodes (LEDs), IS-segment displays, and
watchdog timer
of
the Display Control Panel by way
of
its own controls and displays.
It
also
allows you to see the EPROM version.
To
enter Display Test Mode:
• Enter Manager Settings (or Maintenance Settings).
• Press and hold
O'
D,
and
ISTARTI
together (or
[El,
fl,
and
ISTARTI
together).
• Release
[[J (or
f)).
66
!iTAR
TRAC
4500
TREADMILL
Owner's
Manual
To Next Page
Loading...
