• Listen for a beep and see MANAGER SETTINGS (or MAINTENANCE SETTINGS) in the
display momentarily.
• Release the remaining keys. See UNITS in the Alphanumeric Display.
• Press and release
EJ.
• See that all LEDs are lit.
• Press and release
0.
• See that all LEDs are dark. See the EPROM version, e.g. PWM V3.3, in the Alphanumeric
Display. Or
...
Alternatively, to enter Display Test Mode from Operating (normal) Mode:
• Move the ON/OFF switch (main power switch
@ the rear
of
the unit) to OFF.
• Press and hold
~
while moving the ON/OFF switch to ON.
•
Release(§).
• See that all LEDs are lit.
• Press and release
~.
• See that all LEDs are dark. See the EPROM version, e.g. PWM V3.3, in the Alphanumeric
Display.
The following keys are available in Display Test Mode:
INCLINE
Keys: Lights the % Incline indicators and Alphanumeric Display
character segments one at a time. Keys will repeat
if
held.
C
Heart
Rate
Key: Enters Heart Rate Test Mode below.
I
START
I Key: Displays START START in Alphanumeric Display.
[[E]].
·.
[~]
Number/Program
Select Keys: Display 0 through 9, respectively, in each
alphanumeric Display character segment.
Key: Displays
WD
TEST in Alphanumeric Display. Activates watchdog timer, which
resets the processor and returns the treadmill to Operating Mode. Displays
WD
FAIL
in Alphanumeric Display
if
watchdog timer fails.
To
leave Display Test Mode and enter Operating Mode, press and release
[STOj:lJ.
§TAR
TRAC
4500
TREADMILL
Owner's
Manual
67
To Next Page
Loading...
