Short press — press and release the button, followed by a flash corresponding to the
current operating mode.
Long press — hold the button until LED flashes appear. The duration of the press can be
of two levels:
First-level long press — press and hold the button until two short flashes of the
current operating mode followed by one long flash, during which the button should
be released.
Second-level long press — press and hold the button until two short flashes of the
current operating mode followed by one long flash, then a series of short flashes,
during which the button should be released.
Command Press duration
Arm/Disarm the system 1 short press
Enable/Disable "anti-hijack by tag loss" mode first-level long press
Enable/Disable service mode second-level long press
Replacing the Battery
The tag uses a CR2032 battery.
If the tag battery is low, three sound signals will be heard when the ignition is turned on, and an
SMS message will be sent to the owner’s number. It is recommended to replace the battery as soon
as possible.
To replace the battery, carefully open the tag case with a flat metal or plastic object (metal ruler,
thin plastic). Insert the new battery into the compartment, observing the polarity (as shown in the
photo). Before closing the tag case, place the waterproof gasket between its parts. After installing
the new battery in the tag, the system is ready for use.
n_Метка синяя.png
Image not found or type unknown
Замена элемента питания 2021.png
Image not found or type unknown
To Next Page
Loading...
