Starline S96v2 - Device Registration

User manual
Device Registration
To register new remote keys, tags, smartphones, and other wireless and wired accessories, use the
"Device Registration" mode.
Entering the device registration mode
1. Set the system to "Disarmed" mode.
6.png
Image not found or type unknown
2. Turn off the ignition (if it was on).
off.png
Image not found or type unknown
3. Press the service button or external transceiver button 7 times.
press 7 times.png
Image not found or type unknown
4. Turn on the ignition. There will be 7 flashes of the service button LED and 7 audible
signals.
on.png
Image not found or type unknown
5. Entry into the registration mode will be confirmed by 2 flashes of the service button LED
and 2 audible signals.
valet_2_times.png
Image not found or type unknown
To prevent unauthorized registration of new accessories, entryto registration mode is
permitted in Disarmed mode only. IfImmobilizer mode enabled then authorization must be
passedto fully disarm a system.
Tags and smartphones shall be registered in one registrationcycle. All previously paired
tags and smartphones will bedeleted from memory if not paired again together with the
newones. A total of up to 5 devices can be registered in the system.
When registering new primary and additional remote keys, all previous remote keys will be
removed from memory, and they must be registered again. A total of up to 4 remote keys
can be registered in the system.
All steps of device registration must be completed without long pauses between them.