User manual
Emergency disarming
Use the emergency disarmament code provided on the owner's plastic card or PIN envelope in the
following situations:
Loss of the tag.
Depleted battery in the tag or remote key.
No access to the StarLine mobile application.
"Anti-hijack" mode is activated.
Plastic card
plastic2.png
Image not found or type unknown
Entering emergency disarm code via the
service button
To emergency disarm the system, follow these steps:
1. Ensure that the ignition is on.
on.png
Image not found or type unknown
2. Press the service button a number of times corresponding to the first digit of the
emergency disarm code and switch the ignition off.
push x times.png
Image not found or type unknown
3. After 3 seconds, the digit entry will be confirmed by flashes of the service button LED. The
number of flashes will correspond to the sequential number of the emergency disarm
code digit (1, 2, 3, or 4 times).
4. Repeat steps 1..3 for the remaining digits.
If the emergency disarmament code is entered correctly, the system will emit 3 short sound signals
and 3 light signals, and transition to the "Disarmed" mode.
Example of entering the code 5342 using the service button.
If the emergency disarmament code is entered incorrectly 3 times, the ability to re-enter the
code will be blocked for 15 minutes.
An attempt to enter a digit will be indicated by 5 flashes of the service button LED.
To Next Page
Loading...
