example.png
Image not found or type unknown
Entering emergency disarm code via SMS
command
If the system includes a GSM module, send an SMS command 30 XXXX , where ХХХХ —
emergency disarm code.
Entering emergency disarm code via the
StarLine EC-1 Capacitive Sensor
The emergency disarm code can be entered using the StarLine EC-1 capacitive sensor (installed
optionally).
To disarm the system, follow these steps:
1. Touch the door handle 3 times. A single sound signal will follow.
2. Touch the door handle a number of times corresponding to the first digit of the emergency
disarmament code. The input will be confirmed by a flash of the service button LED.
3. Enter the remaining digits of the code as in step 2. Flashes of the service button LED will
follow. The number of flashes will correspond to the sequential number of the emergency
disarmament code digit (1, 2, 3, or 4 times).
4. If the emergency disarmament code is entered correctly, there will be 2 flashes of the
service button LED and 2 sound signals. The system will transition to the "Disarmed"
mode.
If the code is entered incorrectly, there will be 4 flashes of the service button LED and 4 sound
signals.
If an incorrect emergency disarmament code is sent 3 times, the ability to re-attempt
emergency disarmament will be blocked for 15 minutes, and the owner will receive an SMS
notification.
If the emergency disarmament code is entered incorrectly 3 times, the ability to re-enter the
code will be blocked for 15 minutes.
An attempt to enter a digit will be indicated by 5 flashes of the service button LED.
To Next Page
Loading...
