Beach mode
In "Beach Mode," there is no need for a tag or key fob to enable/disable the security system (they
can be left inside the car). Owner authorization is achieved by entering the emergency disarm code
by touching the door handle with a capacitive sensor StarLine ES-1 (optional). In this mode, the
system does not respond to key fob commands.
To activate "Beach Mode," follow these steps:
1. Switch the system to the "Disarmed" mode and turn off the ignition.
2. Press the service button three times and turn on the ignition. This will be followed by
three audible signals confirming the activation of "Beach Mode."Turn off the ignition.
3. Exit the car and touch the door handle three times. The system will enter the "Armed"
mode.
Exiting the mode is done by entering the emergency disarm code by touching the door handle with
an interval of no more than 3 seconds. The correct input of the code digit will be confirmed by
audible and visual signals, the quantity of which will correspond to the code digit. The correct input
of the code will be confirmed by 2 audible and visual signals.
Video recorder(dashcam) control
The system automatically activates the video recorder for recording in the following cases:
When the ignition is turned on, it activates for 5 minutes;
When switching to the "Alarm" mode or triggering the pre-alarm level, it activates for 2
minutes.
"Beach Mode" deactivates the "Hands-Free" mode until the security system is turned off.
If the emergency disarm code is entered incorrectly 3 times, the possibility of re-entering
the code will be blocked for 15 minutes.
After disarming the system, if no actions or commands are given, the system will
automatically switch to the "Armed" mode after 30 seconds, and the "Beach" mode will
remain active.
The "Video Recorder Control" function is activated by the installation specialist during the
installation of the system.
To Next Page
Loading...
