Starline S96v2 - Engine Start

Requests can be made by the owner with a short press of the key fob button
icon-short-3.png
Image not found or type unknown
or by sending SMS command 41 .
When using the key fob, the information will be displayed on its screen, while SMS requests will
receive a response SMS message.
Engine Start Function
The engine start function allows remote and automatic engine starting/stopping.
Preparing a Manual Transmission (MT) Vehicle for Remote and Automatic Engine Start
Before starting the engine, you need to perform the "Program Neutral" procedure:
1. Engage the parking brake while the engine is running.
2. Remove the key from the ignition switch. The engine will continue to run.
3. Exit the vehicle, close the doors, trunk, and hood, and arm the security system. The
engine will be stopped.
4. The system will enter the "Armed" mode.
5. The key fob will display the "N" icon.
6. The system is now ready for remote and automatic engine start.
Preparing an Automatic Transmission (AT) Vehicle for Remote and Automatic Engine
Star
Ensure that the AT selector is in the "Park" position.
Engine Start
Remote engine start can be initiated by one of the following methods:
Long press of button 1 on the remote key:
icon-long-1.png
Image not found or type unknown
icon-note-1.png
Image not found or type unknown
;
The engine temperature readings displayed by the system depend on the location of the
engine temperature sensor and may differ from those shown on the vehicle's dashboard.
If the request is made during automatic engine start, the remaining engine runtime will also
be displayed in addition to the aforementioned values.
If a door is opened or the ignition is turned on after performing the "Program Neutral"
procedure, remote and automatic engine start will be canceled until the next "Program
Neutral" algorithm execution.