Starline S96v2 - Hands-Free Mode

engine will be blocked for 1 minute or until the owner's authorization code is entered
when attempting to start the vehicle. The code entry waiting time is set from 15 to 60
seconds.
Hands-Free mode
The "Hands-Free" mode is designed for automatic enabling/disabling of the security mode.
You can enable or disable the "Hands-Free" mode using one of the following methods:
вIn the cursor menu of the remote key by selecting the corresponding item;
By SMS commands 71 or 70 , respectively;
By voice menu commands 71 or 70 , respectively;
Via the StarLine mobile app;
Through the personal account on thestarline.onlinewebsite.
There are several options for enabling and disabling the alarm in the "Hands-Free" mode:
Enabling the alarm when the tag is lost from sight
Enabling the alarm by holding the door handle sensor (purchased separately) with the tag
in sight
Disabling the alarm when the tag appears in sight
Disabling the alarm by touching the door handle sensor (purchased separately) with the
tag in sight
If the tag is lost from view while the doors, hood, or trunk are open, the system will notify about
this event in one or more of the following ways:
The "Slave" mode uses a remote key with an LCD. When the standard alarm system
switches to the "Alarm" mode, the message "SLAVE" will be displayed on the remote key
screen.
For changing the method and waiting time for owner authorization, contact the installation
specialist.
By default, the "Hands-Free" mode is disabled. All mode operation parameters are
configured by the installation specialist during installation.
The detection zone and loss are adjusted in the personal account on the starline.online
website (Settings → Main Parameters → Hands-Free).
By default, the tag's operating range is set to the maximum value.