Starline S96v2 - Page 65

Registration of primary and additional
remote keys
1. Press buttons 1 and 2 of the remote key briefly.
but1_but2.png
Image not found or type unknown
2. After 3 seconds, successful registration will be confirmed by a short sound signal from the
remote key, 2 flashes of the service button or transceiver LED, and 2 sound signals. If the
remote key is not registered, the remote key will emit 4 sound signals.
3. Perform steps 1 and 2 for each remote key.
Registration of tags
1. Remove the power element from the tag.
12.png
Image not found or type unknown
2. Press and hold the tag button and insert the power element. The LED of the tag will light
up red.
13.png
Image not found or type unknown
3. Release the button and monitor the series of red flashes for 10 seconds.
14.png
Image not found or type unknown
4. Successful registration will be confirmed by a green flash, 2 flashes of the LED on the
transceiver, and 2 sound signals. If the tag is not registered, the LED of the tag will remain
red.
green 2 times.png
Image not found or type unknown
5. Repeat steps 1-3 for the remaining tags.
Registration of a smartphone:
1. Enable Bluetooth in the smartphone settings.
2. Select StarLine equipment from the list of available devices.
3. Enter the code "000000" (on the iOS platform, press the "Pair" button to enter the code).
Removing a smartphone from the memory
of the security system
If multiple registered smartphones are simultaneously in the vicinity, the system will only
work with the one that connects first.