EasyManua.ls Logo

Starline S96v2 - Page 35

Starline S96v2
77 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
The operation algorithm of the mode depends on the support for reading speed data from the
vehicle's CAN bus (see can.starline.ru for details).
If the function is supported, after receiving the command, the system will activate warning signals
of the upcoming engine block with the siren and hazard lights for 10 seconds. Then, when the
speed drops below 30 km/h, the engine will be blocked.
anti hj.png
Image not found or type unknown
If the function is not supported, after receiving the command, the system will activate warning
signals of the upcoming engine block with the siren and hazard lights for 10 seconds. The engine
will be blocked either after 3 minutes or upon pressing the brake pedal.
Exiting the "Anti-Hijack" mode and unlocking the engine can be done in one of the following ways:
By SMS command 30 XXXX ,where XXXX is the emergency disarm code specified on the
plastic card or pin envelope of the owner
By entering the emergency disarm code specified on the plastic card or pin envelope of
the owner using the service button or transceiver button
From the personal account on the starline.online website. The emergency disarm code
specified on the plastic card or pin envelope of the owner needs to be entered.
Anti-Hijack Mode by Tag or Remote Key Loss
The operation algorithm of the mode depends on the support for reading speed data from the
vehicle's CAN bus (see can.starline.ru for details).
If the speed reading function is supported, the algorithm is as follows:
One of the security zones (doors, hood, or trunk) is breached
The motion sensor is triggered
After 30 seconds, the system will start searching for the tag/remote key
After 30 seconds, if the tag/remote key is not detected, the system will activate the siren
and hazard lights for 10 seconds
When the speed drops below 30 km/h, the engine will be blocked
If the emergency disarm code is entered incorrectly 3 times, the ability to enter the code will
be blocked for 15 minutes, and the owner will receive an SMS notification.
To enable the "Anti-Hijack" mode by owner’s command, go to the personal account on the
starline.online website (Settings → Main Parameters → Anti-Hijack by Tag Loss → Uncheck
the boxes) or in the StarLine mobile application (Settings → Advanced Settings → Main
Parameters → Anti-Hijack by Tag Loss → Uncheck the boxes).

Related product manuals