Starline S96v2 - Page 70

4. The system's transition to the emergency disarm code change mode will be confirmed by
2 short flashes of the service button LED and 2 sound signals.
If there is no activity within 5 seconds, the system will automatically exit the
emergency disarm code change mode.
5. Turn off the ignition.
6. Turn on the ignition and press the service button a number of times corresponding to the
first digit of the current emergency disarm code.
7. Turn off the ignition. The service button LED will light up, and the number of flashes will
correspond to the digit position of the emergency disarm code (1, 2, 3, or 4 times).
8. Repeat steps 6...7 for the remaining code digits.
9. There will be 2 flashes of the service button LED and 2 sound signals, confirming the
correct entry of the current code.
10. Turn on the ignition. Press the service button a number of times corresponding to the first
digit of the new emergency disarm code.
11. Turn off the ignition. The service button LED will light up, and the number of flashes will
correspond to the digit position of the emergency disarm code (1, 2, 3, or 4 times).
12. Repeat steps 10...11 for the remaining new code digits.
13. There will be 2 flashes of the service button LED and 2 sound signals, confirming the
acceptance of the new emergency disarm code.
14. Enter the new code again by repeating steps 10...12.
15. There will be 2 flashes of the service button LED and 2 sound signals, confirming the
recording of the new emergency disarm code.
Example of changing the emergency disarm code using the service
button
To change the current emergency disarm code from 7184 to the new one, 5463, follow these steps:
1. Ensure that the system is in "Disarmed" mode.
2. Press the service button 4 times.
3. Turn on the ignition. The service button will flash 4 times, accompanied by 4 beep
sounds.
4. The system will confirm the transition to the emergency disarm code change mode
with 2 short flashes of the service button LED and 2 beep sounds.
5. Turn on the ignition.
6. Press the service button 7 times. Turn off the ignition.
7. The service button will flash once.
8. Turn on the ignition.
9. Press the service button once. Turn off the ignition.
10. The service button will flash twice.
11. Turn on the ignition.
12. Press the service button 8 times. Turn off the ignition.
13. The service button will flash three times.
14. Turn on the ignition.