Static Solutions CT-8900 Combo Tester Instructions 1/15/2015
34
the default settings, the user should press ‘APPEND’. This will create a new number for that user at the bottom of the list.
• If you would like to insert a new employee at a certain point in the list, select the name you want the user to come before in
the list. Type over the information with the new user’s information. When finished, press INSERT. This will put the new
user ahead of the person you selected.
• Anytime information is changed for a user, use the MODIFY command when finished to save all changes.
• To move between users in the general configuration screen, use the side toolbar under the word list. This will advance to
the next or previous user.
• An employee can be set up as "Exempt" from having to pass the resistance tests. This will allow the employee to open the
door relay (if the system is equipped with a door relay). Set the employee as "Exempt" by either:
o setting the max wrist resistance resistance greater than 10000 (or entering "Exempt"
o setting the WorkGroup to "eXe"
Directories
Can set different directories for the Names.txt file, Log.txt file, report.txt files, and report.csv files in the Setup, Directories window.
Normally these entries are left blank to default to the local EsdTest working directory, but for simple networking, they may be set to
point to the main server directory (see networking help below). If one master log.txt file is used, and if problems arise with multiple
servers writing to it ast the same time, then file locking may be selected by placing a check in the checkbox. If the log.txt file is local
to the computer, this option should not be used (i.e it should not be checked).
Change Employee Password
An option exists to allow employee to enter their own sick time. Enable this option by selecting the Employee Selection Configuration
window, and checking the “Allow employee to change own sick time”. Set a password for this feature by selecting the Change
Employee Password item in the Setup window. If the password is set to no characters, then it will be ignored. When an employee
tests his/her strap, there will be a box that says "Modify Sick Time" on the lower right corner of the main test results window. An
employee can now click this box. The employee password will be asked for (if it was not set blank). A sick time modification window
To Next Page
Loading...
Need help?
General
