Static Solutions CT-8900 Combo Tester Instructions 1/15/2015
7
ISO TRAINING AND CERTIFICATION OF ESD HANDLING AND CONTROL MEASURES FOR
OPERATORS
A comprehensive interactive multimedia learning program with certification for those who work with static sensitive devices is
available as an option. The training is directed to assemblers and support personnel.
Objectives
Participants successfully completing the program will be able to:
• Describe conditions most likely to cause uncontrolled electrostatic discharge
• Identify three types of ESD protective packaging
• Explain the use of ionization and topical antistats for static control
• Describe the impact of environmental factors on static charge
• Describe the function of ESD protective items in a protected area
• List the requirements of an ESD protective workstation
• Describe the correct use of ESD protective smocks, wrist straps, and footwear
• Recognize correct use of personal protection around high voltage hazards
• List recommended ESD protective practices at workstations
Qualification and Certification Testing
The training course incorporates interactive learning checks throughout the instructional sequences. Certification tests are criterion-
referenced and module-based with feedback on every response for enhanced learning. The tests also include a scorebar to provide
the learner with continuous status information. Administrative access to dates and scores of tests, certifications, and re-certifications
is compliant with ISO quality-standards requirements.
Standards Compliant
The courses meet and comply with the ANSI/ESD S20.20 ESD control program guidelines as well as to JEDEC JESD625, IEC
61340-5, and IPC-610 standards.
Learning station system requirements
Install the training course software on the computer that the employees will be trained. The computer learning station will require:
• a PC style Pentium class computer with a Microsoft operating system Windows 2000/XP is preferred.
• a color monitor
• speakers.
• a network connection to the EsdTest server so that the EsdTest server can read the training course data base
• an internet connection to transfer license codes over.
Setup of training courses
The training course is sold on a per seat license basis. A separate license seat must be pre purchased from Static Solutions for each
employee who takes the course. Once the course is taken, a license seat is good for a 12 month period. If you have not purchased
a group of license seats yet, please contact Static Solutions.
The training course installation software is located on our EsdTest installation CD. After installing the EsdTest software, a window
will appear and ask if you would like to install the training software. The software can also be installed later by opening the
LTechCP1 subdirectory on our installation CD, and running Setup.exe. The training course installation manual
LTechInstallationGuide.pdf is also located in that subdirectory.
Install the software on the training course CD, as per the installation directions contained in the training course CD package. Once
the course software is installed, the course software will ask for the company name, telephone number, and email address. Once
this information has been entered, the registration license number will be emailed back, and they can then be entered (or cut and
pasted from the email) into the training program. The company ESD administrator can than either register the IDs of all the
employees who will be taking the course (has to be the same ID as the one entered into the EsdTest sytem data base) into the
training course system, or the employee/trainee can enter his/her employee ID when first registering to take the training course.
Once registered, the trainee can sign in with just his name and ID number.
To Next Page
Loading...
Need help?
General
