NOTICE!
Danger of damage to the inverter or derating!
– The mounting location must satisfy the following conditions:
–
The mounting location and immediate environment are permanently fixed, vertical,
flat, non-inflammable and not subject to constant vibration.
– The permissible ambient conditions are conformed to; see Technical data
Ä
further information on page 70.
– The following free spaces must be present around the inverter:
Above/below: at least 200 mm
At the sides/in front: at least 60 mm
– Do not install the inverter in areas where animals are kept.
– Observe the connection ratings specified on the type plate.
– The DC cables must not be connected to an earth potential (DC inputs and AC output are
not electrically isolated).
NOTICE!
When transmitting data over a public network:
– Transmitting data over a public network can incur additional costs.
–
Data transmitted over a public network is not protected from unauthorised access by
third-parties.
Note
– Avoid exposing the inverter to direct sunlight.
– The display must be readable on the installed device.
EN
747,431 | Z09 | 2015-09-30
34
To Next Page
Loading...
