2 General information
2.1
General safety notices
n This document is part of the product.
n Install and use the device only after reading and understanding this document.
n Always perform the measures described in this document in the sequence specified.
n Keep this document in a safe place for the entire service life of the device. Pass the document
on to subsequent owners and operators of the device.
n The yield of the system can be reduced through improper operation
n If the housing is damaged, do not connect the device to the DC or AC lines
n Take the device out of service immediately and disconnect it from the mains supply and the
solar modules if one of the following components is damagedM
–
Device (not functioning, visible damage, smoke, penetration of liquid etc.)
– Lines
– Solar modules
Do not switch the system on again before
– the device has been repaired by a dealer or the manufacturer,
– damaged cables or solar modules have been repaired by a technical specialist.
n Never cover the device
n Do not open the casing: Risk of death. Invalidation of the guarantee.
n Factory labels and markings must never be altered, removed or rendered unreadable.
n Comply with the instructions of the respective manufacturer when you connect an external
component that is not described in this document (e. g. external data loggers) Components
that are incorrectly connected can damage the device.
Safety information on the device (coolcept Indoor)
①
Dangerous voltages can remain present on the
components up to 10 minutes after switching off the DC
circuit breaker and the line circuit breaker.
②
Comply with the instructions in the manual!
③
Serial number as a bar code and in plain text
EN
747,431 | Z09 | 2015-09-30
6
To Next Page
Loading...
