Steca coolcept - Scope of Delivery, Intended Use, and Manual Details

2.3 Scope of delivery
n Inverter ①, type coolcept (plastic housing) or coolcept-x (stainless steel housing, IP65)
n Mounting plate ② for type coolcept or coolcept-x
n AC plug ③
n 1 pair SUNCLIX plug-in connectors ④
n 3 sealing caps (for RJ45 socket; only coolcept-x) ⑤
n Brief installation and operating instructions⑥
①
②
③
④
⑤
⑥
2.4 Intended use
n The inverter must only be used in grid-coupled photovoltaic systems. The inverter is suitable for
all solar modules with connections that do not need to be grounded.
n Solar modules must be used that have an IEC 61730 class A rating because the inverter does
not have electrical isolation.
n If the maximum AC operating voltage is higher than the maximum system voltage of the
photovoltaic generator, then solar modules must be used that have a maximum system voltage
that is higher than the AC grid voltage.
Note
An overview of suitable solar modules is available at
www.stecasolar.com
Þ PV GRID
CONNECTED
Þ Service and support.
EN
747,431 | Z09 | 2015-09-30 9