4.
Press s. The next value is selected.
5. Repeat steps 1 to 4 for the remaining values.
6. Press ESC. The next higher menu level is displayed.
Calling up the service menu and editing the values
NOTICE!
Risk of yield losses and contravention of regulations and standards. Inverter and grid
parameters can be changed in the service menu. The service menu must therefore only be used
by technical professionals who know the applicable regulations and standards.
1. Select the Service
menu item.
2. Press SET. The fig. shown at the left appears.
3.
Press rs simultaneously for 3 seconds. The service menu is
displayed (Fig. left).
4.
Press rs to select a menu item.
5. Press SET to edit the menu item. The following applies:
n Enter the password if required (Fig. left); see
Ä
3.3.4, S. 22
n If necessary, press rs within a menu item to display and
edit other settings (e.g. Voltage limits).
n The menu items are described in
Ä
3.3.4, p. 22.
5.4 Internet portal
Notes
The following illustrations show examples in English.
EN
747,431 | Z09 | 2015-09-30
53
To Next Page
Loading...
