NOTICE!
If cosPhi = 1 was not selected, an additional
menu item Load defaults is indicated.
1.
Press s to select "Load defaults".
2. Press SET.
3.
Press rs to select a default characteristic line.
4. Press SET.
ð
The default characteristic line is adopted.
5. Press ESC.
✓ The check list is shown.
1. Press SET.
ð
The value flashes.
2.
Press rs to change the number of nodes.
3. Press SET.
ð
The value is adopted.
4. Press ESC.
✓ The check list is shown.
Loading defaults
Number of nodes
EN
750.661 | Z03 | 2016-09-12
40
To Next Page
Loading...
