150
Global Effects
Effects Reference
Ring Modulator
The Ring Modulator provides a sine oscillator that is multiplied with the input signal.
This creates metallic, or bell-like, frequencies. The integrated LFO modulates the
frequency of the sine oscillator to vary the created frequencies over time. In addition,
an envelope follower is available, which can be used to modulate the frequency of the
sine oscillator depending on the level of the input signal.
LFO Waveform and LFO Shape
These are the same parameters as on the LFO subpages, see “LFO Waveform and
Shape” on page 51.
LFO Freq
Use this to specify the frequency of the LFO for modulating the frequency of the sine
oscillator.
Sync
Activate this to set the LFO Freq value in fractions of beats.
LFO Depth
Sets the intensity of the LFO modulation of the sine oscillator frequency.
Frequency
Determines the frequency of the sine oscillator.
Mix
This sets the ratio between the dry and the wet signal.
Envelope Follower
The Envelope Follower traces the input signal with an adjustable attack and release
time and delivers a modulation signal representing the level envelope of the signal.
Sensitivity
All input signals are downmixed to mono before they are sent to the Envelope
Follower. The Sensitivity parameter sets the optimum input level for the Envelope
Follower.
Attack
This adjusts the attack time of the Envelope Follower, that is, the time the Envelope
Follower needs to approach increasing input levels.
Release
This adjusts the release time of the Envelope Follower, that is, the time the Envelope
Follower needs to approach decreasing input levels.
Depth
Determines the output level of the modulation signal of the Envelope Follower.
To Next Page
Loading...