Software
UR44 Operation Manual 20
REV-X (Reverb)
Overview
REV-X is a digital reverb platform developed by
Yamaha for pro audio applications.
One REV-X effect is included in this unit. Input
signals can be sent to the REV-X effect, and the
REV-X effect is applied only to the monitor outputs.
Three types of REV-X are available: Hall, Room, and
Plate.
The hardware REV-X equipped with the device and
REV-X of the VST Plug-in version have essentially
the same parameters. However, the [OUTPUT] and
[MIX] parameters are only available in the VST Plug-
in version. When using REV-X on Cubase series
programs, you can share the settings between the
built-in REV-X and REV-X of the VST Plug-in version
as a preset file. When using the built-in REV-X on
Cubase series programs, turn on the “Direct
Monitoring” setting in the program. Also, when
assigning REV-X of the VST Plug-in version to the
effect slot on Cubase series programs, select it from
the “Reverb” category (in the case of the default
settings).
The built-in REV-X is equipped with an “FX Bus”
which is used for sending the signal from DAW
software to REV-X. For example, to send the
recorded audio data to REV-X, you can check the
sound with REV-X, which is used for monitoring
during the recording.
How to Open the Window
From Dedicated Windows for Cubase Series
• Click “REV-X Edit” (page 16) in the section “Input
Settings Window.”
• Click “REV-X Edit” (page 17) in the section “Reverb
Routing Window.”
From dspMixFx UR44
Click “REV-X Edit” (page 13) in the section “Master
Area.”
Controls and Functions
NOTE
This section uses the Hall type of REV-X as an example.
1 Reverb Time
Adjusts the reverb time. This parameter links to Room
Size. The adjustable range varies depending on the
REV-X type.
2 Initial Delay
Adjusts the time that elapses between the direct,
original sound and the initial reflections that follow it.
Range: 0.1 msec – 200.0 msec
3 Decay
Adjusts the characteristic of the envelope from the
moment the reverberation starts to the moment it
attenuates and stops.
Range: 0 – 63
4 Room Size
Adjusts the size of the simulated room. This parameter
links to Reverb Time.
Range: 0 – 31
5 Diffusion
Adjusts the spread of the reverberation.
Range: 0 – 10
6 HPF
Adjusts the cutoff frequency of the high pass filter.
Range: 20 Hz – 8.0 kHz
REV-X type Range
Hall 0.103 sec – 31.0 sec
Room 0.152 sec – 45.3 sec
Plate 0.176 sec – 52.0 sec
To Next Page
Loading...
