33
© 2012 Stenograph, L.L.C.
Chapter 3, Writing on the Diamante, provides an overview of the Diamante menus and details Diamante
features. Some of the detailed features include loading dictionaries, setting audio options, viewing SD
card directories, creating J-Defines and searching steno and text on the Tilting screen.
Diamante Setup
Installing the Diamante USB drivers on your computer is necessary in order to write realtime with a USB
cable, load dictionaries and install updates. The Diamante USB drivers are located on the
Diamante
®
/Wave
™
Utilities and Tutorial CD, which comes with your Diamante. See Install the Diamante
USB Drivers on page 18.
Before writing on your Diamante, ensure there is a Data SD and Backup SD in the appropriate SD slots
and charge the battery. The Diamante uses a Data SD card to store steno notes, timestamps, audio files
when the audio option is selected and the associated job dictionary when J-Defines are created for the
job.
The Backup Secure Data (SD) card that comes with your Diamante is used as a backup for your steno
notes, timestamps and audio. This card is formatted at the Stenograph factory. If you insert a different
SD card in the Backup SD slot, it must be formatted in the Diamante before you can begin writing. The
Diamante requires a Backup SD card in order to operate.
Although you can use the Diamante with the AC adapter/charger, Stenograph recommends that you
charge the battery in your Diamante before using it for the first time. See Batteries on page 14 for
detailed information about charging your battery.
Tutorial Clips
The Diamante
®
/Wave
™
Utilities and Tutorial CD contains short videos with audio designed to assist you
in learning about select Diamante features. See Introduction on page 7.
Chapter 3
Writing on the Diamante
To Next Page
Loading...
