Need help?Do you have a question about the Steris Evolution Series and is the answer not in the manual?
General| Power Requirements | 120 VAC, 60 Hz |
|---|---|
| Material | Stainless steel |
| Type | Surgical Table |
| Leg Section Tilt | -90° to +30° |
| Table Width | 20 in (50.8 cm) |
Keyhole slots along loading car frame provide support points for adjustable shelving.
Insert side gates into keyhole slots on loading car uprights.
Use following instructions to adjust transfer carriage height for proper placement in sterilizer chamber.
Check and adjust dock locking function after height adjustments for proper operation.
Adjust front caster travel stops for single door sterilizer units.
Adjust front caster travel stops for double door sterilizer units.
Instructions for steering and braking using the casters on the loading car.
Step-by-step guide for loading the car into the sterilizer.
Step-by-step guide for unloading the car from the sterilizer.
Procedures for cleaning the Evolution Loading Car and Transfer Carriage.
Procedures for lubricating the hand crank threads and bearing.
To Next Page