5-4
P129391-130 Operator/Maintenance Manual Operating Instructions
Unloading Instructions
STEP 1: Open chamber door.
STEP 2: Move transfer carriage forward until it engages with dock.
STEP 3: Once transfer carriage engages with dock, transfer
carriage latches to dock as it begins pushing into
chamber.
STEP 4: Push carriage fully into chamber.
STEP 5: Turn hand crank clockwise until loading car is fully lifted
from supports in chamber.
STEP 6: Withdraw car and carriage from chamber.
STEP 7: Transfer carriage disengages from dock when fully
withdrawn from chamber.
• Pull carriage away from sterilizer.
STEP 8: Close chamber door.
STEP 9: Transfer load from sterilizer area.
WARNING – BURN HAZARD:
• Sterilizer, rack/shelves and
loading equipment will be
hot after cycle is run.
Always wear protective
gloves and apron when
removing a processed load.
Protective gloves and
apron must be worn when
reloading sterilizer
following the previous
operation.
• Steam may be released
from the chamber when
door is opened. Step back
from the sterilizer each time
the door is opened to
minimize contact with
steam vapor.
WARNING – SLIPPING
HAZARD: To reduce slippery
floor conditions, keep floors
dry by immediately wiping up
any spilled liquids or
condensation in sterilizer
loading or unloading area.
To Next Page
Loading...
