i
P129391-130
A WORD FROM STERIS CORPORATION
©2018, STERIS Corporation. All rights reserved. Printed in U.S.A.
This manual contains important information on proper use and
maintenance of the Evolution™ Loading Car and Transfer Carriage.
All personnel involved in the use and maintenance of this
equipment must carefully review and comply with the warnings,
cautions, and instructions contained in this manual. These
instructions are important to protect the health and safety of
personnel operating an Evolution Loading Car and Transfer Carriage
and should be retained in a conveniently accessible area for quick
reference.
Advisory
Any alteration of this equipment not authorized or performed by
STERIS which could affect its operation will void the warranty and
could also violate federal, state or local regulations.
A listing of Safety Precautions to be observed when operating and
servicing this equipment can be found in Section 1 of this manual.
Do not operate or service the equipment until you have become
familiar with this information.
Indications for Use
The Evolution Loading Car and Transfer Carriage is intended for
loading and unloading Evolution™ or Evolution™-L sterilizers and for
transferring goods to and from processing areas.
A thorough preventive maintenance program is essential to safe and
proper unit operation. This manual contains maintenance schedules
and procedures which should be followed for satisfactory equipment
performance.
Important: The only sterilizer configurations available for healthcare
applications in North America are HC-600 (660 x 660 x 991 mm [26 x
26 x 39”]) and HC-1500 (660 x 953 x 1676 [26 x 37.5 x 66”]).
To Next Page
Loading...
