Release 00 - 11/2018
page 17
9
8
5. TANK AND SUPPLY
5.2. Cleaning the tank
1 - Remove the tank [
5.1].
2 - Slide out the lter tube (8) and blow compressed
air through it so as to remove any deposits inside.
3 - Keeping the hole (9) in the spigot closed, pour
about 100 cc of clean petrol into the tank and
shake it vigorously to clean the inside.
4 - Empty the tank and dispose of the petrol used
for cleaning in accordance with the laws in force.
5 - Ret the tank [ 5.1] tightening the screws
(6) to the torques indicated.
6 - Replace the starter assembly by securing the
nuts (4) at the specied torque.
WARNING:Beforerellingthetankwithnew
fuel, check that the petrol pipe is intact.
5.3. Checking and cleaning the breather pipe
1 - Remove the cap (10) and pull out the gasket
(11) and the sponge (12).
2 - Check that:
- the gasket (11) is intact and without cracks or
ssures;
- the air passages (13) inside the cap are not clog-
ged;
- the sponge (12) is not crushed or broken.
NOTE: Always replace the entire cap if the
gasket or sponge is damaged.
Tightening torques
4
Fixing nuts, starter assembly
6-10 Nm
6
Tank xing screw
8-12 Nm
10
10
11
12
13
To Next Page
Loading...
Need help?
General
