EasyManuals Logo

Stiga WBE170 Workshop Manual

Stiga WBE170
59 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #44 background imageLoading...
Page #44 background image
Release 00 - 11/2018
page 44
Engine WBE 170
Workshop Manual
16. ENGINE BLOCK - Overhauling internal parts
2
1
3
All the following operations on the grass cutter ne-
cessitate the removal of the motor.
16.1. Carter opening
1 - Loosen the lever xing nut (1), release the spring
(2) and remove the control lever (3).
2 - Position the engine on a stable support and
remove the sparkplug.
Bring the piston to the TDC (Top Dead Centre).
3 - Turn the engine upside down and place it with
the shaft pointing upwards.
4 - Unscrew the nine screws (4), recovering the two
centring pins (5) and remove the engine sump with
the help of levers.
5 - Check the timing between the engine shaft and
camshaft, partially removing the shim ring;
If necessary, re-set the phasing, referring to the
indications provided.
6 - On assembly, follow the steps described in re-
verse and:
- clean the contact surfaces, removing any remai-
ning silicone;
- evenly distribute the silicone seal (THREE BOND
1207) (6) as shown in the gure;
- ensure that the two centring pins (5) are properly
inserted;
- always replace the compression ring from the
sump side [
15.6].
- close the screws (4) intersection lock sump to the
indicated couple;
7 - After installing the engine on the machine:
- rell the sump and make sure that the ller plug
is tight.
- check correct the brake control cable adjustment
[ 13.1].
8 - Following reassembly, it is advisable to check
the engine’s rpm [ 10.1].
5
6
5
4
4
<< BACK >>
INDEX

Table of Contents

Other manuals for Stiga WBE170

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Stiga WBE170 and is the answer not in the manual?

Stiga WBE170 Specifications

General IconGeneral
BrandStiga
ModelWBE170
CategoryEngine
LanguageEnglish

Related product manuals