Stihl FS 45 - Page 35

No. Part Name Part No. Application Rem.
24 Assembly stand 5910 890 3100 Holding FS units
25 - Clamp 5910 890 8800 Holding FS units by drive tube
for servicing
(in conjunction with assembly stand)
26 Assembly drift 1114 893 4700 Installing piston pin
27 Wooden assembly block 1108 893 4800 Fitting piston
28 Clamping strap 0000 893 2600 Compressing piston ring
Remarks:
1) Locking screw 4112 893 1200 may be used as an alternative.
2) Equivalent to puller 0000 890 4400, but with longer sprindle 5910 890 8400.
3) Setting gauge 1111 890 6400 may be used as an alternative.
4) Always use torque wrench to tighten DG/P screws.
5) Wrench has optical/acoustic signal.
6) On DG/P screws, use for releasing only.
FS 45 35