Stihl MS 271 Manual

107MS 271 C, MS 291 C
No. Description Part No. Application Rem.
18 Installing tool 10 5910 890 2210 Installing hookless snap rings in piston
19 Screwdriver 5910 890 2306 Adjusting the carburetor
20 Screwdriver bit, T 27 x 150 5910 890 2400 IS-P screws
21 Hook 5910 890 2800 Detaching springs on clutch shoes
22 Assembly stand 5910 890 3101 Holding saw for repairs
23 Puller 5910 890 4400 Removing oil seals
24 Puller 5910 890 4502 Pull off the limiter cap.
25 Puller 5910 890 4504 Removing flywheel
- Jaws (No. 3.1) 0000 893 3706 Removing oil seal(s)
26 Stud puller M8 5910 893 0501 Removing bar mounting studs
27 Setting disk 5910 893 6600 Add-on for screwdriver (adjusting
carburetor)
28 Hook 5910 893 8800 Removing pickup body
Remarks:
1) Use for releasing only.

Stihl MS 271 Specifications

General

Motor type	2-stroke motor
Chain gauge	1.6 mm
Chain pitch	3/8 \
Blade length	400 mm
Automatic oiling	Yes
Oil tank capacity	0.24 L
Fuel tank capacity	0.5 L
Engine displacement	55.5 cm³
Engine power	3.8 hp
Power source	Gasoline

Weight and Dimensions

Weight	5600 g