Stihl Msa 200 c User Manual

MSA 200 C
English
75
N Hold the machine with both hands –
wrap hands tightly around the
handles
N Make certain that the saw chain has
not yet been positioned for cutting
and is not touching any other
objects
N Pull hand guard towards the front
handle until it engages audibly and
the hand guard is in the position ‚
– chain brake is released
N Press trigger switch lockout (1) with
thumb
N Depress trigger switch (2) with
index finger
N Guide the machine into the wood
with the saw chain running
The motor will not run unless the hand
guard is set to ‚ and the trigger switch
lockout (1) and trigger switch (2) are
pressed at the same time.
Trigger switch
The motor speed can be controlled
using the trigger switch. The more the
trigger switch is depressed, the higher
the motor speed.
N Release trigger switch (2) so that it
springs back into its original position
– in the original position, the trigger
switch is once again blocked by the
trigger switch lockout (1)
The coasting brake stops the saw chain.
N Set the hand guard to ƒ – the saw
chain is blocked
During breaks and after work, remove
the battery from the machine.
3999BA010 KN
2
3999BA016 KN
1
Switching Off
2
3999BA017 KN
1
3999BA009 KN

Stihl Msa 200 c Specifications

General

Battery Type	Lithium-Ion
Voltage	36 V
Power Source	Battery
Chain Gauge	0.043 in (1.1 mm)
Chain Pitch	1/4 inch
Vibration Level (Front Handle)	2.5 m/s^2
Bar Length	12-14 in. (30-35 cm)