MSA 200 C
English
83
Maintenance and Care
The following information applies under normal operating conditions. The specified intervals must be
shortened accordingly when working for longer than normal each day or under difficult conditions
(extensive dust, highly resinous lumber, lumber from tropical trees, etc.).
Always set the hand guard to
ƒ and remove the battery before starting any work on the machine.
before starting work
at the end of work and/or
daily
each time the battery is
changed
weekly
monthly
yearly
if faulty
if damaged
as required
Complete machine
visual inspection (condition, leaks) X
clean X
Control handles (hand guard, trigger switch lock
-
out and trigger switch)
Checking operation XX
clean XX
Chain brake, coasting brake
Checking operation X
have checked by a specialist dealer
1)
XX
Lubricating oil tank clean X
Chain lubrication check XX
Saw chain
check, pay attention to sharpness XX
Check the chain tension XX
sharpen X
Guide bar
check (wear, damage) X
clean and turn over XX
deburr X
replace XX
Chain sprocket check X
Cooling air intake slits
visual inspection X
clean X
Battery visual inspection XXX
Battery compartment
clean XX
Check operation (battery ejection) X