Stihl Msa 200 c User Manual

MSA 200 C
English
91
Running time is too short
Battery is not completely charged Charge battery
Service life of battery has been reached
or exceeded
Check battery
1)
and replace
Cutting attachment dirty Clean cutting attachment
Battery gets stuck during insertion in the
machine/charger
Guides / contacts dirty Carefully clean guides / contacts
Battery does not charge although the LEDs
on the charger are green
Battery too hot / too cold
(1 LED on battery is red)
Let the battery cool off / let the battery
warm up gradually at temperatures of
approx. 15 °C - 20 °C
Operate the charger only in a closed, dry
space at ambient temperatures of +5 °C
to +40 °C
LED on charger flashes red
No electrical contact between charger
and battery
Remove battery and reinsert it
Battery fault
(4 LEDs on the battery flash red for
approx. 5 seconds)
Remove battery from the machine and
reinsert it. Turn on the machine – if the
LEDs still flash, the battery is faulty and
must be replaced
Fault in charger Have charger checked by a servicing
dealer
1)
1)
STIHL recommends STIHL servicing dealers
Always remove the battery from the machine before starting any work on the machine.
Fault Cause Remedy

Stihl Msa 200 c Specifications

General

Battery Type	Lithium-Ion
Voltage	36 V
Power Source	Battery
Chain Gauge	0.043 in (1.1 mm)
Chain Pitch	1/4 inch
Vibration Level (Front Handle)	2.5 m/s^2
Bar Length	12-14 in. (30-35 cm)