– The message is specific to trucks with the
DLC 3 option or the second lifting block op-
tion. The message warns that the second
maximum height level set for the forks has
been reached ("second block height excee-
ded warning"). The message "OK" will ap-
pear on the display.
– To delete the message and be able to lift
the forks and the load higher, keep the first
button on the right on the keypad (D) press-
ed for around three seconds.
– The message warns that, for safety rea-
sons, the operator must lower the straddles
to be able to lift the forks higher.
– The message may appear on the display
when lifting approximately 1700 mm from
the ground (only for trucks with platform and
side protection). To remove the message
from the display, lower the load or close the
operator side protection (for more informa-
tion, also see
⇒
Chapter "Location of labels",
Page 55 ):
CAUTION
The operator must assess whether to close the side
protection before lifting the forks higher.
OM2305
1/1
ERROR
OM2298
1/1
ERROR
Overview
3
Instruments and controls
36 45758043484 EN - 11/2021 - 08
To Next Page
Loading...
