Fourth "DLC 3" option example: The
weight of the load on the forks slightly
exceeds the maximum permissible ca-
pacity.
– The weight of the load on the forks is
1450 kg (± 50 kg)
– The maximum permissible load on the forks
is 1400 kg.
The following signals will warn the operator
that the weight of the load on the forks is
(1450 kg ±50 kg) and is just beyond the
maximum permissible capacity (1400 kg):
●
The truck emits a warning sound (once).
●
At the same time, a
yellow
warning triangle
appears on the display.
– The arrow shown on the display is pointing
downwards. The operator must lower the
forks. The warning triangle will then disap-
pear. The truck does NOT automatically
stop the lifting of the forks!
The height of the forks is NOT the cause of
the danger and warning signals:
●
The maximum permissible height of the
forks is 3.3 m.
●
The forks are at a height of 2.9 m.
NOTE
When the lift measured is higher than the
permissible lift, a similar warning will be dis-
played.
Fifth "DLC 3" option example: The
weight of the load on the forks far ex-
ceeds the maximum permissible capaci-
ty.
– The weight of the load on the forks is
1550 kg (± 50 kg)
– The maximum permissible load on the forks
is 1400 kg.
The following signals will warn the operator
that the weight of the load on the forks is
(1550 kg ±50 kg) and is far beyond the maxi-
mum permissible capacity (1400 kg):
●
The truck emits a warning sound.
●
At the same time, a
red
warning triangle ap-
pears on the display.
– The arrow shown on the display is pointing
downwards. The operator must lower the
forks. The warning triangle will then disap-
pear and the warning sound will stop.
– The truck stops the forks lifting!
– The operator can, however, continue lifting
by authorizing the operation as explained
below.
– Confirm the warning message." Capacity
exceeded." using the Confirm button. The
warning sound will not stop until the forks
are lowered. When the lift measured is
Overview
3
Options and variants
6945758043484 EN - 11/2021 - 08
To Next Page
Loading...
