Operation 5
Shut-down
7071_003-111
4
5
5
Inserting a wheel chock
The wheel chock (special equipment) serves,
among other things, to prevent the forklift truck
from rolling away on a slope.
– Lift the handle (4) on the support mounting.
– Remove the wheel chock (5) from the sup-
port mounting.
– Place the wheel chock on the downhill side
behind a wheel on the front axle.
NOTE
After using, return the wheel chock to the sup-
port mounting and press the handle (4) down
again.
Measures for prolonged shutdown,
storage of truck
If the truck is to be stored for a prolonged time,
the following measures must be taken to pro-
tect against corrosion.
If the truck is to be shut down for more than two
months, it must be parked in a clean and dry
area. The area should also be well ventilated
and frost free. The following additional mea-
sures must be taken:
Measures before shutdown
– Clean truck thoroughly; see ⇒ Chap-
ter "Cleaning", P. 196.
– Lift fork carriage to full extent several times.
– Tilt the mast forwards and backwards sev-
eral times and, if fitted, move attachments
repeatedly.
– To relieve the strain on the load chains,
lower forks onto a suitable supporting sur-
face e. g. a pallet.
– Check the hydraulic oil level and refill as
needed; see ⇒ Chapter "Maintaining hy-
draulic equipment", P. 6-207.
– Apply oil or grease thinly to all uninsulated
moving parts; see ⇒ Chapter "Lubricating
joints and controls", P. 6-211.
171673 [EN] 173
To Next Page
Loading...
Need help?
General
