Maintenance 6
General maintenance information
Ordering spare parts and wearing
parts
Spare parts are provided by our spare parts
service department. The information required
for ordering spare parts is shown in the spare
parts list.
Only use spare parts as per the manufac-
turer’s instructions. The use of unapproved
spare parts can result in an increased risk of
accidents due to insufficient quality or incor-
rect assignment.
Anyone using unapproved spare parts is fully
liable without restriction in the event of dam-
age or harm.
Quality and quantity of the required
operating materials
Only the operating materials specified in the
maintenance data table may be used.
Consult the maintenance data table for the
consumables and lubricants needed for main-
tenance. See ⇒ Chapter "Maintenance data
table", P. 6-186.
Different quality oil and grease types may not
be mixed. This negatively affects the lubricity.
If a change between different manufacturers
cannot be avoided: remove the old oil particu-
larly thoroughly.
Before performing greasing, filter changes or
any intervention in the hydraulic system, care-
fully clean the area around the part involved.
When topping up consumables, use clean
containers only!
171673 [EN] 185
To Next Page
Loading...
Need help?
General
