3 Safety
Essentials for safe operation
For safety reasons, it is prohibited to drill holes
in the driver’s overhead guard or to perform
welding on it. In the case of welding to other
locations of the forklift truck, the battery and
all connections to the electronic control cards
must be disconnected. Please contact your
service centre.
DANGER
Failure to comply with the above voids the CE con-
formity!
Operation of the forklift truck without the overhead
guard at a lift height of over 1800 mm is prohibited.
Warning regarding non-original parts
Original parts, attachments and accessories
are specially designed for this vehicle. We
specifically draw your attention to the fact that
parts, attachments and accessories supplied
by other companies have not been tested and
approved by us.
CAUTION
Installation and/or use of such products may there-
fore have a negative impact on the design features
of your industrial truck and thus impair active and/or
passive driving safety.
We recommend that you obtain approval from us
and, if necessary, from the responsible regulatory
authorities,beforeinstalling such parts. The manuf-
acturer accepts no liability for any damage caused
by the use of non-original parts and accessories
without our approval.
Damage, defects and misuse of
safety devices
The driver must report any damage or other
defects to the truck or attachment immediately
to the supervisory personnel.
Trucks and attachments that are not functional
or safe to drive may not be used until they have
been properly repaired.
Do not remove or deactivate safety devices
and switches.
24 171673 [EN]
To Next Page
Loading...
Need help?
General
