Operation 4
Lifting
– Notify your service centre
Load chains not under tension
DANGER
Danger caused by a falling load!
– Make sure that the chain(s) does (do) not
become slack when lowering the load.
Slack chains can, for instance, result from:
• Resting the fork carriage or the load on the
racking.
• Fork carriage rollers becoming blocked in
the lift mast due to contamination.
– If the fork carriage or the load comes to an
unexpected stop, lift the fork carriage until
the chains are under tension again and
lower the load at another suitable location.
– If the fork carriage rollers in the lift mast
become blocked due to contamination, lift
the fork carriage until the chains are under
tension again. Remove the contamination
before resuming work.
WARNING
Risk of injury!
– Observe the safety reg
ulations for working on lift
masts; see ⇒ Chapter
"Working at the front of the
truck",P.5-374.
Hydraulic blockin
g function
The hydraulic bloc
king function ensures that
all the functions o
f the working hydraulics
are disabled whenev
er the seat switch in the
driver's seat is unloa
ded.
If the driver stands u
p from the driver's seat,
the blocking function p
revents the hydraulic
functions that:
• Lift the load
• Lower the load
• Tilt the lift mast
• Additional functions
171
533 EN - 02/2019 - 19 177
To Next Page
