4 Operation
Checks and tasks before daily use
6327_003-047_V2
3
4
5
1
2
To assist with climbing into and out of the truck,
the footwell must be used as a step (4) and the
handle (1) must be used for support. The post
oftheoverheadguard(5)canalsobeusedfor
support.
Always climb into the truck in
aforwards
motion:
– Grip the handle (1) with your left hand and
hold on.
– Put your left foot on the step (3).
– Enter the truck with your ri
ght foot first and
sit down on the driver's sea
t(2).
Always climb out of the truck backwards:
– Grip the handle (1) with your left hand and
hold on.
– Stand up from the driver'
s seat and place
your left foot on the step
(3).
– Climb out of the truck right foot first.
Adjusting the MSG 65/MSG 75
driver's seat
DANGER
There is a risk of accident if the seat or seat backrest
shifts suddenly, which could cause the driver to
move in an uncontrolled manner. This may result in
unintentional actuation of the steering or operating
devices and thus cause the truck or load to move in
an uncontrolled fashion.
– Do not adjust the seat or seat backrest while
driving
– Adjust the seat and the seat backrest so that all
operating devices can be actuated safely
– Ensure that the seat and seat backrest are
securely engaged
WARNING
On some equipment variants, the
amount of head clearance on the truck
may be restricted.
On these specific equipment variants,
the distance between the head and
the lower edge of the roofing sheet
must be at least 40 mm.
78 1
71533 EN - 02/2019 - 19
To Next Page
Loading...
