Operation 4
Checks and tasks before daily use
Component
Course of action
Attachments (variant)
Ensure that the attachments are mounted correctly
in accordance with the operating instructions from
the manufacturer.
Perform a visual inspection to ensure that the attach-
ments are intact and are leak-tight.
Perform checks to ensure the attachments are
working correctly.
Lift cylinders, tilt cylinders, tank, valve
block, hoses, pipes, connections
Perform a visual inspection for damage and leak-
ages.
Have damaged components replaced by the autho-
rised service centre.
Underside
Check the area under the truck for leaking consum-
ables.
Wheels, tyres
Perform a visual inspection for wear and damage.
Make sure that only rims of the same type from the
same manufacturer are fitted.
In the event of uneven tyre wear, replace both tyres.
Observe the safety regulations in the section entitled
"Tyres".
Axle
Make sure that no consumables are escaping from
the axle.
Overhead guard, guard grille (variant)
Perform a visual inspection for integrity.
Check for secure mounting.
Steps
Make sure they are clean (free of ice, not slippery).
Panes of glass (variant)
Perform a visual inspection for integrity.
Make sure they are clean (also free of ice).
Handholds
Check for
secure mounting.
Maintenance lids
Check the close function and close.
Battery hood
Make sure that there are no unused bores in the
battery hood.
Battery cover
Perform a visual inspection for integrity and defor-
mation.
Check that the interlock is in good condition and is
working correctly.
Check the close function.
Close.
Battery
Check that the interlock is in good condition and is
working correctly.
Lock the battery.
171
533 EN - 02/2019 - 19 75
To Next Page
Loading...
