SatLink VSAT User Guide
Publication no. 101557
Copyright © 2009 – STM Group, Inc.
Page 117 (160)
4. In order to start sending packets to the port listener type ip udpsend –start. This will start
sending the packets as shown in the following figure.
UDPSEND will be automatically stopped after count number of packets are pumped,
else stop the packet generator using the stop command i.e. stop the task using the taskstop
command
Internal UDP receiver for testing satellite link to hub
IP UDPRECV module receives UDP traffic with embedded packet identification on receiving, missing
packets can be found by looking at the identification. This can be used to check the link issues.
UDPRECV can be configured to work in different ways; UDPRECV can receive traffic from single host
(or) two hosts. UDPRECV will receive traffic until explicitly stopped by the user.
To Next Page
Loading...
