SatLink VSAT User Guide
Publication no. 101557
Copyright © 2009 – STM Group, Inc.
Page 125 (160)
E.6 Definition of STM SatLink VSAT interface Numeration
This section provides the background for the chosen numbering of the interfaces of the STM SatLink
VSAT.
The STM SatLink VSAT has two interfaces:
• The Ethernet (LAN) interface
• The satellite (DVB) interface
The Ethernet (LAN) interface of the STM SatLink VSAT has been assigned the number 1 and the Air
(DVB) interface has been given the number 3. Interface number 2 is not in use.
These interface numbers are predefined and automatically configured in the RCST.
E.7 Adding an Entry to the QoS Classification Table
CreateAndGo is not available when adding a new entry to the
ipQos.qosClassificationTable. Instead a new row must first be created
as CreateAndWait before being activated as shown in the example below.
E.7.1 Example - Configure an entry in the QoS classification table using MGSoft
MIB browser v9.0.0.
1. Add an entry in the table by using set on the qosClassRowStatus.
Then set the value 5 (CreateAndWait) for the OID 1.3.6.1.4.1.3286.50.2.5.5.1.1.14.N where N is the
index wanted for the new entry (index 3 in the example below).
Figure 41: Define new row as CreateAndWait
To Next Page
Loading...
